您好,欢迎访问深圳市苏山伟达通讯设备有限公司官方网站!

致力于智慧城市、XPON光网络通信工程

提供从产品到通信规划设计方案的服务
服务热线:

0755-89605209

首页 > 新闻资讯 > 技术解答 >

GPON OLT ONU配置命令

【发布时间:2018-06-13 17:02:48】

GPON OLT ONU配置命令

首先配置OLT板子,

configure system max-lt-link-speed link-speed ten-gb 这ten-gb可以是twodotfive-gb或者其他值,但一定要比板子的speed要大。比如OLT板子是10G的,这里要大于等于10.

configure equipment slot lt:1/1/1 planned-type fgxt-a 这里是规定了插入该rack/shelf/slot的板卡类型

接下来就是对PON口的配置了,首先我们需要把admin的状态启起来

configure interface port pon:1/1/1/1 admin-up 这里是rack/shelf/slot/port

然后就是对该PON口下联的ONU进行配置了

configure equipment ontinterface 1/1/1/1/2 sernumxxxxsw-ver-pland noplanned voip-allowed enable 对rack 1, shelf 1, slot 1, port 1的第2个ONU进行配置。这里应该是ONU –ID与serial number的绑定。

后面是对ONUcard的配置

configure equipment ont slot 1/1/1/1/2/1 planned-card-type10_100base plndnumdataports 4 plndnumvoiceports 0 admin-state up 在ONU上,可以有不同的card。

这时候其实物理层的配置已经结束了,ONU已经可以注册到OLT上了。